Trail-tech KICKSTAND 5001-CR Uživatelský manuál stáhnout pdf

LIMITED WARRANTY

TRAIL TECH INC. WARRANTS TRAIL TECH KICKSTAND PRODUCTS TO BE FREE

FROM DEFECTS IN MATERIAL AND WORKMANSHIP UNDER NORMAL USE AND IF

PROPERLY INSTALLED FOR A PERIOD OF SIX MONTHS FROM DATE OF PURCHASE.

IF FOUND TO BE DEFECTIVE AS MENTIONED ABOVE, IT WILL BE REPLACED OR

REPAIRED. THIS SHALL CONSTITUTE THE SOLE REMEDY OF THE PURCHASER

AND THE SOLE LIABILITY OF TRAIL TECH INC. TO THE EXTENT PERMITTED BY

LAW, THE FOREGOING IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES OR

REPRESENTATIONS WHETHER EXPRESSED OR IMPLIED, INCLUDED ANY LIMITED

WARRANTY OF MERCHANTABILITY OR FITNESS. IN NO EVENT SHALL TRAIL TECH

INC. BE LIABLE FOR SPECIAL OR CONSEQUENTIAL DAMAGES.

IMPORTANT: WEAR EYE

PROTECTION WHEN HANGING

SPRINGS!

Note: After every ride it is important to check your kickstand

thoroughly for the following:





Damaged or broken parts can result in serious injury! If any part of

your stand has become

damaged do not ride the machine! Contact a factory trained

technician or Trail Tech directly for service or repairs.









Tech Support: 360-687-4530

[email protected]

HONDA CR 125R/250R 02-03

HONDA CRF450R 02-03



5100-PK CONTENTS:



5100-PK Parts Kit





 5905-04 CR/CRF Kickstand Spring.

 Spring Hanger Tab.



 Remove stock foot-peg, foot-peg hardware, & foot-

peg hanger from frame.

 Install provided Trail Tech foot-peg bracket, using

the OEM fasteners.







 Re install foot peg & foot-peg hardware following

manufacturers recommended installation procedure.

 Remove the stock sub-frame fastener and insert

through the provided spring hanger tab (Fig. 1B)

 Re-install the sub-frame fastener, and tighten down

hand tight to start.









5001-CR Kickstand Installed

 Hook spring into spring hanger mounting tab shown

in (Fig. 2)

 Using safety glasses & a spring puller stretch the

spring and latch it onto the stand arm mounting point

(Fig. 2)

 Tighten sub-frame fastener to manufacturers torque

specification.



Spring Hanger Tab

Stand Arm

Mounting Point

1 2

Shrnutí obsahu

Strany 1 - SPRINGS!

LIMITED WARRANTYTRAIL TECH INC. WARRANTS TRAIL TECH KICKSTAND PRODUCTS TO BE FREE FROM DEFECTS IN MATERIAL AND WORKMANSHIP UNDER NORMAL USE AND IF PR

Strany 2

Tech Support: [email protected]

Příbuzné modely KICKSTAND 5011-CR

Komentáře k této Příručce

Žádné komentáře

Trail-tech KICKSTAND 5001-CR Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Pro motocykly Trail-tech KICKSTAND 5001-CR. Trail Tech KICKSTAND 5001-CR User Manual Uživatelská příručka

Shrnutí obsahu

Příbuzné modely KICKSTAND 5011-CR

Komentáře k této Příručce

Související produkty a manuály pro Pro motocykly Trail-tech KICKSTAND 5001-CR